Filter
Top Products
21
Iss 4
Operating your Scooter
Basic Driving
1. Make sure you are properly seated on the scooter and that the Speed
Control knob is turned fully to the left, towards No 1.
Note: Reverse movement of the scooter may not occur when
Speed Control Dial is turned fully anticlockwise and
reversing up a slope.
2. Turn the key switch to the On position.
3. On the tiller, use the throttle lever as described earlier. You will gently
accelerate. Release and you will gently stop. Practice these two basic
functions until you get used to them.
4. Steering the scooter is easy and logical. Be sure to remember to allow
enough clearance when turning corners so that the rear wheels clear
any obstacle.
5. Shortcutting a pavement corner can cause the back wheel to go off
the pavement, causing problems, if the corner is very rough. Avoid this
at all times by steering an exaggerated curve around the obstacle.
6. When steering in a tight spot, such as entering a doorway or when
turning around, stop the scooter and then turn the handlebar to where
you want to go, then apply power gently. This will make the scooter
turn very sharply. It is also recommended that the preset speed is set
to a slower setting to aid control in tight spots.
Exercise caution when reversing
7. Reversing requires attention.
Right hand pull or left hand push operation of the throttle lever will move
the scooter in reverse.
When reversing, always turn the handlebars in the opposite direction
to the way you want to go.
The more you pull the throttle lever, the faster you will go.
Reverse speed is 50% slower than forward speed. If the scooter does
not move in reverse, carefully turn the speed control knob clockwise
until the scooter moves gently backwards.