930331 Rev.F
7
930331 Rev.F
6
2. Opposite Side Assembly (Fig. 8)
a. Add one washer (5a) to axle (1).
b. Insert axle with washer through bearings
in axle plate.
c. Add spacer (2) to axle.
d. Add wheel (4) to axle.
e. Insert key (3) into keyway on axle (1).
f. Add washer (5b) and nut (6).
g. Tighten.
3. Drive Shaft Mounting (Storage)
Brackets (Fig. 9)
a. Mount drive shaft mounting (storage)
brackets to chair in either position
shown.
NOTE: For Zippie GS, lower side frame is the only
storage mounting option
4. Installing Drive Shaft Assembly
(Fig. 10 & 10a)
a. Compress, twist and lock drive shaft
assembly.
b. Attach assembly to one axle tab.
c. Unlock assembly and attach to opposite
axle tab.
IV. ASSEMBLY
B. INSTALLING HUBS
1. Installation (Figs. 5 & 6)
a. Thread screw (4) partially through
threaded hub (3) to position hubs on
both sides of wheel.
b. Insert alignment tool or axle with key
(2) through hub and wheel assembly,
aligning keyways.
c. Add washer (5) and thread nut (6)
on alignment tool.
d. Tighten nut until both hubs are fully
seated in wheel.
e. Install screws on hubs in sequence
shown (Fig. 6) using 1/8” Allen wrench.
f. Remove screw (4) and alignment
tool (2).
C. ASSEMBLING COMPONENTS
1. Drive Side Assembly (Fig. 7)
a. Mount handrim hub to handrim on dual
handrim side.
b. Add one washer (2a) to axle (1).
c. Insert axle with washer through bearings
in axle plate.
d. For Quickie & Zippie Series:
Add four washers (2b) to axle.
For Breezy Series: Move washers (2c) as
spacers for outer handrim (6) and wheel
assembly (4). Add or remove washers to
adjust spacing.
e. Add spacer (3) to axle.
f. Add wheel (4) to axle.
g. Add another washer (2c) to axle.
h. Insert key (5) into keyway on axle (1).
i. Slide handrim assembly (6) on to axle.
j. Add washer (2e) and nut (7).
k. Tighten.
IV. ASSEMBLY
Fig. 5
Fig. 6
1
2
4
3
5
6
Fig. 7
1
2a
2b
3
4
2c
5
6
7
2e
or
inside
outside
1
2
3
4
5b
6
Fig. 8
Fig. 9
Fig. 10
Fig. 10a (Quickie TS)
5a
1
3
5
4
2
6