Filter
Top Products
6
Care and Cleaning continued
Changing the foil and cutter blocks
• Shaving performance depends on the
condition of the foil and the cutter
blocks. Both wear gradually in use.
Therefore it is recommended that the
shaving foil be changed once a year and
the cutter blocks changed every two
years.
Replacing the shaving foil
• Remove the shaver head by pressing the
two release buttons.
• Pull the shaving foil out of the shaver
head by holding it on the attached straps
(fig. 4).
• Place the new shaving foil in the shaver
head until it clicks in position.
• Replace the shaver head.
Replacing the cutter blocks
• Remove the shaver head
• Hold the cutter blocks on both sides and
lift them from their supports (fig. 5).
• Place the new cutter blocks in position.
• Replace the shaver head.
Help Line
If you have any additional questions about using the Washable Shaver, please call the
Sunbeam help line in Australia on 1800 025 059. In New Zealand, please call
0800 786 232.
Figure 5
Figure
4