Filter
Top Products
1. Ensure that the control dial is in the ‘O’ off
position.
2. Place the product on a firm, level floor
3. Place a chair behind the unit and adjust its
position until you can sit comfortably with
your feet inside the appliance (without
water).
4. Place a towel within easy reach to dry your
feet afterwards.
5. Using a large jug, fill the foot spa with water.
Do not fill above the maximum level
indicated.
6. Do not use hot water as this will make your
feet sweat.
7. Insert the plug into a 230-240 volt power
outlet and turn on.
8. Sit in the chair and place your feet in the
appliance.
9. Turn the switch to the setting you wish to
use –
Setting 1 – Massage, Heat & Infra-red
heat
When using this setting, the appliance will
maintain the temperature of the water which
you have added. It will not heat cold water.
To increase the intensity of the massage,
move your feet backwards and forwards
over the rollers in the base of the appliance.
If the rollers are not required simply remove
and replace with the plain insets. Place the
sole of your foot on the infra-red panel to
soothe and ease aches and pains. This
also helps with the absorption of any
treatment creams.
Setting 2 –Massage, Heat, Infra-red heat
& Bubbles
This setting will also make the water bubble
for an invigorating treatment. Use all these
features when feet are tired and sore.
Setting 3 – Bubbles & Heat
Using the Pedicure Centre
Push one of the attachments onto the fitting
on the pedicure centre. Press lightly with
your foot to activate. Maintain pressure
whilst moving the attachment over the sole
of the foot. Use the Cleansing Brush
attachment to gently cleanse the foot. Use
the Pumice Stone attachment to rub away
hard skin which will have been softened by
the water. Use the Massage attachment to
massage all over your foot. Use the
Reflexology Attachment to massage a
particular part of the foot. Lift your foot from
the unit to stop it rotating. Lift the
attachment straight up to remove it.
10. Do not use the product for more than 20
minutes.
11. When you have finished using the
appliance, return the switch to the ‘O’ off
position and remove your feet from the unit
and dry thoroughly.
12. Turn off power outlet and remove plug.
13. Discard the water.
6
Using Your Pedicure Foot Spa