Filter
Top Products
snug for a short while; this is normal. Try to remain
relaxed, refrain from talking, and be as still as pos-
sible during the measurement Note: If the unit
determines that the initial inflation pressure was
insufficient, it will re-inflate to a higher pressure.
4) After the measurement cycle is finished, the
unit will release any remaining air in the cuff.
The systolic and diastolic pressure will be dis-
played for 5 seconds and then be replaced by
the pulse rate. The blood pressure reading and
pulse rate will then be displayed alternately.
For any reason you feel a need to end a meas-
urement, just press the ON/OFF button to turn
off the monitor and release the cuff pressure.
If during a measurement the power drops to an
insufficient level, the monitor will end the meas-
urement and display the low battery symbol.
Please replace the batteries and repeat the
measurement.
If the monitor cannot detect your pulse, it will
end the measurement attempt. Wait a few min-
utes, make sure that the cuff is positioned prop-
erly, and try again.
The monitor will automatically shut off 3 minutes
following a reading, or it can be turned off man-
ually by pressing the ON/OFF button.