Filter
Top Products
Measurement in
progress
Exhaust
A.
,
Insui’ficient
pressure
Replace
batteries
Measurement error
PU
ERR
Pulse error
Mark appears in the mea-
surement condition and
flashes when pulse is
detected.
Mark flashes when power is
applied and there is air
remaining in the cuff.
Measurement has begun
but the pressure was
insufficient.
Appears when the battery
voltage is excessively low.
Appears when the blood
pressure could not be
obtained accurately.
Appears when the pulse
rate could not be obtained
accurately.
Measurement in progress
-
remain quiet.
Automatic exhaust is per-
formed.
Raise the cuff
pressure 30-40
mmHg
more andmeasure once
again.
Replace all four batteries
with new ones.
Exhaust the air from the
cuff, and re-apply the cuff
properly and re-measure.
(Wait 10 minutes before
re-measure)