Filter
Top Products
VIBRATOR HEADS — PARTS & OPERATION MANUAL — REV. #1 (04/22/02) — PAGE 9
VIBRATOR HEADS— MAINTENANCE
Figure 3. Head Parts
MAINTENANCE
The vibrator heads should be inspected and lubricated after
every 100 hours of use. Refer to (Figure 3).
CAUTION!CAUTION!
CAUTION!CAUTION!
CAUTION!
DO NOT allow the vibrator head to wear below
the following dimensions: See General
Specifications - page11.
To Disassemble a Vibrator Head:
1. Remove the flexible shaft from the head. Heat should be
applied to the threads to break down the anaerobic sealant.
This will help prevent possible damage to the threads.
Threads are left-hand.
2. Remove the casing adapter from the housing. Head should
be applied to the threads to break down the anaerobic
sealant. Threads are right-hand. (Ref. 9)
3. Remove the hardened tip from the housing. Heat should
be applied to the threads to break down the anaerobic
sealant. Threads are right-hand. (Ref. 1,12)
Reference
Number Description
1 ....................... Housing
2 ....................... Nut or Screw
3 ....................... Bearing
4 ....................... Spindle
5 ....................... Seal
6 ....................... Spacer
8 ....................... Fitting Adapter
9 ....................... Casing Adapter
10 ..................... Shim
11 ..................... Flat Washer
12 ..................... Tip