Filter
Top Products
8
ASSEMBLY INSTRUCTIONS
STEP 2
Remove your AeroPilates Premier Studio from its packaging placing the product on its side, with the
LOCKING PIN(29) side upward. Remove the LOCKING PIN(29) and unfold the MAIN FRAME ASSEMBLY
separating the half that has the attached LOCKING PIN(29). When completed, the frame should be separated
approximately three feet at the end.
STEP 3
Attach the four RUBBER FEET(28) to the FRONT FRAME(1) and REAR FRAME(2) with ROUND HEAD
SCREWS(M5x0.8x25mm)(38). Attach the WHEELS(27) to the FRONT FRAME(1) with WASHERS(M8)(47)
and NYLOCK NUTS(M8x1.25)(42).
STEP 4
Unfold your AeroPilates Premier Studio to a flat position by moving the FRONT FRAME(1) away from
the platform end of the product in a clockwise position until fully extended.