Filter
Top Products
1.
2.
3.
4.
5.
6.
Enter the current
MPIN
(Master Personal Identification Number)
on the SC-001, SC-002.
Press [B].
Press the number key to identify which zone to add the panic
transmitter to. Do not program the transmitter to zone
1,2,3,4.
The panic transmitter is designed to be programmed in zone 5
for SC-001 and zone 9 for SC-002.
Therefore, press
[5]
for SC-001 and press
[9]
for
SC-002.
The zone light(s) will flash for eight seconds.
While the zone light(s) are flashing, press [ *I. Now both the
green and red lights flash for 30 seconds.
While the zone lights are flashing, activate the panic transmitter
by pressing the button on the transmitter. The red LED light of
the sensor will flash. You will hear a long beep from the control
panel, the zone light will stop flashing and the panic transmitter
will now communicate to that zone.
The Panic Transmitter operates on three 3-volt
lithium
batteries that are installed at the
factory. The battery life of these lithium batteries is approximately three years. There are
two screws on the back of the transmitter that hold the top and bottom case together.
Recommendation: Test your transmitter periodically to ensure that all the batteries are
working.
To replace the Panic Transmitter batteries:
?
_
Undo the two screws on the back of the transmitter. The bottom case will then come
off.
2. Take out all the old batteries using a small screwdriver or a pen.
3. Place the new batteries in position. The positive end should be facing upward as you
place the batteries in the transmitter (refer to diagram)
4. Close the battery cover and reinsert two screws.
Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com