Filter
Top Products
4/27/2006
20
Battery Charging Procedure
Charging the Shoprider compact Powerchair:
Smartie, Jiffy & Jiffy11
1) Plug the A/C power cord into the wall. Plug the male three-pin
charger plug into the female 3-pin receiver located on the
bottom of the VSI (Refer to Figure 3, #8). Note: the Jiffy &
Jiffy11 battery pack must be turned on to accept charge.
Jiffy & Jiffy11
2) Remove the battery-pack from the unit. Plug the A/C power
cord into the wall. Located on the battery-pack is a charger port.
Slide the charger port cover over to expose the charger female
3-pin receiver. Plug the male three-pin charger plug into the
female 3-pin receiver. It is not necessary for the battery-pack to
be attached to the Powerchair to charge.
The battery charger’s light indicator is as follows:
Red - Charging
Green - Charging complete
Depending on the amount of battery discharge, the charge time can
take up to 12 hours (Jiffy/Jiffy11 Only). The battery charger has an
electronic switch that will terminate the charge when the batteries are
fully charged. Do not remove the battery charger until the charging
cycle is complete. Be sure to unplug charger from the wall first before
unplugging charger from the Powerchair & turn battery pack off
(Jiffy/Jiffy11 only).
WARNING! Only use the original manufacturer approved
charger!
This charger is for indoor use only. Do not expose it to rain or
water spray.
Do not leave the charger plugged into the Charging Port if the
charger is not charging.