Filter
Top Products
~15~
GMP
ISO9001
ISO14001
ISO13485
CERTIFIED
FOOTREST ADJUSTMENTS (Fig. 9) STREAMER (888-WB/WAB/WSB) WIZZ (WNL)
LENGTH
Pull out the safety pin (1)
from the first hole in the
footrest slide tube (2), adjust the footrest slide tube
and refit the safety pin in the hole at the
desired length.
ANGLE
Release the lock nut and adjust the bolt under the footrest
(3) to adjust the
footrest angle. When the angle desired is reached, re-tighten the lock nut and bolt.
ARM ADJUSTMENTS (Fig.10) STREAMER (888-WB/WAB/WSB) WIZZ (888-WNL)
ANGLE
Pull up on the end of the armrests and they will flip
back up allowing easy transfer in and out of the
seat. Under the armrest there is a bolt and lock nut (1)
that can be adjusted up or down to change the angle
of the armrest.
LENGTH
Located under each armrest is a hand knob (2). By turning counter-clockwise to
release, the armrest can be extended and reset in position by re-tightening the
hand knob.
HEIGHT
Below the armrest on the down supporting tube there is a screw and lock nut (3)
that can be allowed for adjustments. Two aligned hex screws prevent any loose
play.
WIDTH
Beneath the rear of the seat there are two hand knobs, one on each side. Release
the hand knob and slide each arm assembly outward. Re-tighten the hand knob
when in the desired position.
ADJUSTMENT PROCEDURES
Fig. 9
(2)
(3)
(1)
(1)
(3)
Fig. 10
(2)