Filter
Top Products
Problem: Gel is too runny.
Solution: Adjust TEMPERATURE CONTROL DIAL to a
lower setting.
Problem: Unit fails to heat.
Solution: Ensure the unit is plugged in and turned on. Top red
light illuminates and blinks. After one to 3 minutes, the red light
stops blinking and the unit is ready to dispense hot gel/lather.
Problem: Unit does not dispense gel.
Solution: Unit is not properly mounted to the gel can. Remove
unit from the can and reattach, ensuring a secure fit on top of
the can. Or ensure the lather can is using the lather nozzle and
perfectly locked.
Problem: The gel/lather is too hot or too much steam is emitted.
Solution: Adjust TEMPERATURE CONTROL DIAL to lower
setting, or replace can if it has a low amount of gel/lather.
Troubleshooting Guide
14