Filter
Top Products
5 — English
WATERPROOF FEATURE
Only the camera and camera cable are waterproof. All other
components of the scope are water-resistant and should
never be submerged.
Do not use this product for diving or any other prolonged
underwater use. If the camera is exposed to rain or immersed
in water, wipe it dry as soon as possible.
NOTE: Moisture or condensation does not indicate a mal-
function of the waterproof feature.
Changes in temperature (such as moving the camera from
a cold place into a warm place) may cause condensation
in the form of water droplets on the lens or the inside of the
camera. This is normal for all cameras. If this happens, turn
the camera off and remove the battery cap and battery. Place
it in a cool, dry area and leave the battery cap open. Wait at
least an hour before you turn it on again.
TO INSTALL/REMOVE BATTERY PACK
See Figure 2, page 6.
To install the battery pack:
Unscrew the battery cap.
NOTE: Do not remove the gasket inside the cap.
Insert the battery pack in the direction shown. Make sure
the raised rib on the battery pack aligns with the groove
in the inspection scope.
Place the cap over the battery pack and push until the cap
meets the threads at the end of the battery compartment.
Screw the cap on securely.
To remove the battery pack:
Power the inspection scope off. Unscrew the cap. The
battery pack will disconnect and be easy to remove.
Do not attempt to use this product if the battery cap is
not securely closed.
POWER BUTTON
See Figure 1, page 6.
When the inspection scope is turned on and the camera is
pointed at an object, the LCD screen will show the image
the lens is pointing at.
To turn on:
Press and hold the power button.
Release the power button when the screen turns on.
To turn off:
Press and hold the power button.
Release the power button when the screen turns off.
NOTE: The scope with shut off automatically if unused for
five minutes.
ROTATE BUTTON
See Figure 1, page 6.
Pressing this button rotates the LCD image 180º. Push the
button again to return the image to its original position.
LED BRIGHTNESS/DIMMER BUTTON
See Figure 1, page 6.
There are three levels of brightness for the LEDs. The lower
right button turns the LEDs on and increases the brightness
level.
The top right button decreases brightness and turns the
LEDs off.
OPERATION
NOTE: Maintenance information begins on page 6 after
French and Spanish language sections. Figures (illustrations) start on page 7.
This product has a Two-year Limited Warranty.
For Warranty details go to www.ryobitools.com