Filter
Top Products
4—Panel Descriptions
24 S-1608/S-0816 Digital Snake Owner’s Manual
9—[PHANTOM +48 V] Button
Each S-1608/S-0816 System’s input channel can provide +48 V phantom power to connected devices
that require it (such as condenser microphones and active direct boxes).
Press the [PHANTOM +48 V] button so its indicator lights to turn on phantom power on the currently
selected input channel.
To turn off phantom power, select the desired channel and press [PHANTOM +48 V] so its indicator
goes out.
10—POWER Indicator
This indicator lights when power is supplied to the S-4000R. (Power is supplied via the RS-232C cable
when the S-4000R is connected to a powered-on S-1608 or S-0816.)
11—REAC Indicator
This indicator lights when REAC communication is established within the S-1608/S-0816 System. If
REAC communication fails, this indicator will flash.
12—CTRL Indicator
The indicator lights when the S-4000R is connected to a powered-on S-1608 or S-0816 and
communication is established
S-4000R Rear Panel
fig.4-06.eps
1—REMOTE Connector
Use the supplied RS-232C cable to connect the S-4000R’s REMOTE connector to the REMOTE
connector on either the S-1608 or S-0816.
Always turn the phantom power off when connecting any device other than condenser microphones
that require phantom power. You risk causing damage if you mistakenly supply phantom power to
dynamic microphones, audio playback devices, or other devices that don’t require such power. Be
sure to check the specifications of any microphone you intend to use by referring to the manual that
came with it. (This instrument’s phantom power: 48 V DC, 14 mA Max.)
See
Appendix B: Connector Information
for a diagram of the REMOTE (RS-232C) connector.
S-1608_e.book 24 ページ ２００７年４月２３日 月曜日 午後１２時５７分