Filter
Top Products
7
English
Troubleshooting
Possible reason Solution
Pillows won’t seal properly, are uncomfortable or cause red marks
Pillows may have
been fitted incorrectly,
incorrectly adjusted, or
the headgear is too tight.
Carefully follow instructions in “Fitting your Swift LT”.
Check headgear is not over-tightened.
Check ResMed logo on top of pillows is facing
outwards.
Inner wall position of one/
both pillows is incorrect.
Squeeze pillow sides to release inner wall. The
correct position in shown in “Reassembling your
Swift LT”.
Pillows are wrong size. Talk to your clinician.
Pillows may be dirty. Clean pillows according to instructions in “Cleaning
your Swift LT in the Home”.
Nasal pillows system is too noisy
System is assembled
incorrectly.
Reassemble the Swift LT. Make sure the pillows are
fully inserted into the frame.
Before using your Swift LT
WARNINGS
The vent holes must be kept clear. •
The mask should not be used unless the CPAP system is turned on and •
operating properly.
Follow all precautions when using supplemental oxygen. •
Oxygen flow must be turned off when the flow generator is not operating, •
so that unused oxygen does not accumulate within the flow generator
enclosure and create a risk of fire.
At a fixed flow rate of supplemental oxygen flow, the inhaled oxygen •
concentration varies, depending on the pressure settings, patient breathing
pattern, mask, point of application and leak rate.
The technical specifications of the mask are provided for your clinician to •
check that they are compatible with the flow generator. If used outside
specification or if used with incompatible devices, the seal and comfort of
the mask may not be effective, optimum therapy may not be achieved, and
leak, or variation in the rate of leak, may affect the flow generator function.
Discontinue using the Swift LT if you have ANY adverse reaction to the use •
of the mask, and consult your physician or sleep therapist.
As with all masks, some rebreathing may occur at low CPAP pressures. •
Refer to your flow generator manual for details on settings and operational •
information.
Remove all packaging before using the mask. •