Filter
Top Products
4
Swift FX Bella Gray
Fitting
The Swift FX Bella Gray fitting illustrations in this user guide show the
sequence for obtaining the best fit and comfort when using your mask.
Fitting steps
1. Hold the pillows at your nose ensuring that the ResMed logo
is on the top of the pillows facing up. Pull one strap around
and behind your ear.
2. Ensure the strap lies flat and is not twisted.
3. Repeat steps 1 and 2 with the other strap.
4. Adjust the mask fit by pulling the upper straps along the
notches until a comfortable fit is achieved. Repeat with the
lower straps. Do not overtighten.
5. Check that the nasal pillows are positioned upright in the
entrance of your nostrils.
6. Finally, connect the free end of the short tube assembly to
the device air tubing. The mask is now fitted and ready for
use.
WARNING
Using Swift FX Bella Gray may cause ear soreness. If symptoms
occur, consult your physician.
Removing your mask
To remove your mask, place your fingers underneath the straps and lift
them away from your ears.
Disassembly
Refer to the Swift FX Bella Gray disassembly illustrations in this user
guide.
Disassembly steps
1–2. Remove each buckle by slightly twisting the buckle and pulling
away from the node on the pillows.
3–4. Gently push the swivel ring up and pull out of the cushion.