Filter
Top Products
3Using the S8 Lightweight II
Using the S8 Lightweight II
!
WARNING
• Make sure the power cord and plug are in good condition and the
equipment is not damaged.
• Only ResMed air tubing should be used with the device. A different type
of air tubing may alter the pressure you actually receive, reducing the
effectiveness of your treatment.
• Blocking the hose and/or air inlet of the device while in operation could
lead to overheating of the device.
!
CAUTION
• Be careful not to place the device where it can be bumped or where
someone is likely to trip over the power cord.
• If you put the device on the floor, make sure the area is free from dust
and clear of bedding, clothes or other objects that could block the air
inlet.
• Make sure the area around the device is dry and clean.
Set Up the S8 Lightweight II
1 Connect the power cord to the socket at the rear of the S8 Lightweight II.
2 Plug the other end of the power cord into the power outlet.
3 Connect one end of the air tubing firmly onto the air outlet.
4 Connect the assembled mask system to the free end of air tubing.
For information on assembling your mask, see your mask manual.
1
2
3
4