ResMed S8 Escape II Auto Sleep Apnea Machine User Manual


 
7Using the Data Card to Collect data
English
Your clinician can set any of the following reminders on your LCD:
Using the Data Card to Collect data
If your clinician needs to review your treatment, they will ask you to use the Data
Card to copy data from your S8 Escape II Auto, and to return the card to them.
Copying data onto the Data Card
1 Switch on the S8 Escape II Auto and wait until you see the standby
(RAMP/SETTLE) screen.
2
Hold the Data Card with the arrow facing up and insert it into the Data Card slot
until it stops. Data copying starts automatically.
The “Card Inserted Please Wait” message is displayed on the LCD screen while
data is being copied. Copying takes approximately five seconds.
The “Copy Complete Remove Card” message is displayed on the LCD screen
when copying has finished.
3
Remove the Data Card by gripping the end of the Data Card and pulling it out.
4
Store the Data Card in its protective folder when not in use.
5
Return the card in its protective folder to your clinician using a postal envelope.
Message Description Action
INSERT
CARD
May appear if your
device is Data Card
enabled.
Insert your Data Card and follow any
instructions that your clinician has given you.
When you have done this, the message will
disappear from the LCD. Pressing (Ok)
will also remove the message.
REPLACE
MASK
May appear when
your mask is due for
replacement.
Press (Ok) to remove the message from
your LCD, and replace your mask with a new
one.
CALL
PROVIDER
May appear as a
reminder to contact
your clinician, eg, to
discuss how your
therapy is going.
Press (Ok) to remove the message from
your LCD, and contact your clinician.
REPLACE
FILTER
May appear as a
reminder to replace
the air filter on your
device.
Press (Ok) to remove the message from
your LCD, and replace the air filter.
SERVICE
DUE
May appear as a
reminder to return
your device for
service.
Press (Ok) to remove the message from
your LCD, and contact your clinician.