Filter
Top Products
English
5
6. Repeat the previous step with the other headgear arm. Ensure
that the headgear straps are not twisted.
7. Thread the fabric back strap through each side of the headgear,
then fold over to secure. Ensure that the fastener is on the
outside with the ResMed logo facing out.
Cleaning your mask in your home
Your mask and headgear should only be handwashed by gently
rubbing in warm (approximately 30°C) water using mild soap. All
components should be rinsed well with drinking quality water and
allowed to air dry out of direct sunlight.
WARNING
Do not use aromatic-based solutions or scented oils (eg,
eucalyptus or essential oils), bleach, alcohol or products that
smell strongly (eg, citrus) to clean any of the mask components.
Residual vapours from these solutions can be inhaled if not
rinsed thoroughly. They may also damage the mask, causing
cracks.
CAUTION
If any visible deterioration of a system component is
apparent (cracking, crazing, tears etc), the component
should be discarded and replaced.
Avoid connecting flexible PVC products (eg, PVC tubing)
directly to any part of the mask. Flexible PVC contains
elements that can be detrimental to the materials of the
mask, and may cause the components to crack or break.
Daily/After each use:
To optimize the mask seal, facial oils should be removed from
the cushion after use.
Handwash the separated mask components (excluding
headgear).