Filter
Top Products
4
Disassembling for Cleaning
See section C on the illustrations sheet.
Before disassembling the Mirage Swift II, disconnect the flow generator
tubing. To do this, hold the swivel and pull it away from the flow generator
tubing.
CAUTION
Do not pull on the short tube or the flow generator tubing as they may get
damaged.
• To disassemble the Mirage Swift II for daily cleaning, follow steps 1–3.
• To disassemble the Mirage Swift II for weekly cleaning, follow steps 1–5.
1 Detach the short tube assembly. To do this, hold the elbow and pull it away
from the seal ring (C-1).
Note: The short tube assembly cannot be taken apart.
2 Remove the cap by pulling it away from the seal ring (C-2).
3 Detach the headgear ring from the pillow sleeve assembly. Simply pull the
headgear rings from the ends of the frame (C-3).
4 Disassemble the pillow sleeve assembly. To do this, slide off the clip (C-4a)
and then peel the pillow sleeve off the frame (C-4b).
Note: When sliding the clip, hold it at one end, not in the middle.
5 The seal rings do not need to be removed from the headgear (C-5).
Cleaning the Mirage Swift II in the Home
Notes:
• Wash your hands before cleaning the mask.
• Wash the headgear before first time use, as the dye may run. It is important
to always handwash the headgear.
• The headgear may be washed without being disassembled.
Daily
Handwash the pillow sleeve assembly, short tube assembly and cap in warm
(approx. 30°C), soapy water for one minute. Use pure soap. Rinse the
components well with drinking quality water and allow to air dry out of direct
sunlight and heat.
Note: Ensure that the vent holes are not blocked. Use a soft bristle brush to
clean the vent.
60891r1.book Page 4 Monday, April 24, 2006 8:44 AM