4. To trim around the ears and short
hairs at the
nape of the
neck simply
press the
release button
and slide
the pop-up
detail trimmer
outward. Be
careful not to
touch the ears or to press too hard.
5. Make sure to check over the entire
head for any uneven areas.
9
Giving a Comfortable,
Even Cut
Allow the clipper to cut through the
hair without moving it too quickly.
Moving the clipper too quickly may
create a pulling sensation.
Use short strokes when cutting, and
initially use the longest setting. You
can always use a closer setting later
if you want a closer cut.
How to Give a Haircut
1. Start at the back of the head.
Holding the clipper as shown,
lightly stroke upward making sure
you are taking off the desired
amount of hair. Work your way up
to the crown of the head. When
completed, move clipper over and
cut down the head to the nape
of the neck. The SCC-100R is a
bidirectional hair cutter so you can
cut in either direction.
2. Repeat the same procedure across
the back of the head. Make sure
the length of the hair is trimmed to
the same length on both sides of
the head.
3. To cut the hair at the top of the
head, cut
from the
front to the
back in both
directions
until the
hair is cut to
the desired
length.
Cleaning
Before You Begin
1. The hair clipper shall be detached
from the power supply cord before
cleaning.
2. The hair clipper shall not be used
until it has dried.
How To Clean
1. First remove the attached comb
from the clipper by pulling it firmly
away from the blades.
2. For best
results, you
can remove
the inside
blade guard
to expose the
blades.
3. Then use
the brush
provided to
sweep away hair clippings from
the product.
4. This device can also be rinsed
under the faucet to remove any
remaining debris.
5. After cleaning is complete,
reassemble the blade guard to
the product by snapping it into its
original position.
6. Reattach the comb to the product.
Note:
After rinsing, the blades should
be oiled for optimum performance
and product life.
Blade Care
The life of your clippers will depend
on frequency of use, care, and hair
type and condition. The Shortcut
Clipper blades are lubed for life for
your convenience. However, if you
rinse the product under running
water, an oil bottle has been provided
to re-oil the blades.
8
Usage Tips Cleaning and Maintenance
This appliance is a
washable product,
the hand-held part
of which may be
cleaned under water.
35505_SCC-100R_RC_IB.indd 8-9 1/15/08 1:56:50 PM