Filter
Top Products
at a time to
prevent mixing cutter
components. (These
should be kept as
sets). After cleaning,
place cutter retainer
assembly in the hair
pocket, and secure
by turning center
knob approximately
1/4 turn clockwise.
Caution: Never put the shaver completely
under water. Do not use any aggressive
cleansing agent as this may destroy the
shaver coatings.
■ To clean and lubricate your shaver’s cut-
ters and head assembly, apply Remington
®
Shaver Saver
®
(SP-4) Lubricant. The lubri-
cant helps remove hair clippings while
reducing wear.A quick spray after each
shave keeps your shaver operating at peak
performance.
Caution: Do not remove or replace the head
assembly while shaver is running or plugged
into an electrical outlet as it may cause
damage to the unit’s cutters.
■ Worn or damaged parts should be
replaced with Remington
®
branded
replacement parts only.
11
10
Cleaning your shaver
TO ASSURE OPTIMAL PERFORMANCE, IT IS
RECOMMENDED THAT YOU CLEAN YOUR
SHAVER AFTER EACH USE.The cutting system
of this shaver was designed to be cleaned by
rinsing under warm running water or by
brushing.
Cleaning your Remington
®
branded shaver is
easy.
■ Open the hair pocket by pressing the release
button and rotating away from the body of
the shaver.You
may blow out the
stubble thoroughly,
or rinse the shaver
head in water.
Rinse both sides of
the head assembly.
■ At Least Once a Week:
For more complete cleaning, remove the
cutter retainer assembly from the hair
pocket by turning the center knob
approximately 1/4 turn
counter clockwise.
Hold cutter retainer
assembly as shown,
and remove head by
turning approximately
1/8 turn in the direc-
tion shown. Brush
clean both the head
and the cutter. Reassemble head to cutter
retainer assembly by aligning and turning
head 1/8 turn in the opposite direction.
Repeat this process for each of the 3
heads. Clean each head and cutter set one
Cleaning & Maintenance
When is it time to replace your heads
and cutters?
It is very important to replace your heads and cutters
when necessary to insure a close, comfortable shave
without irritation. We recommend they be replaced
every 12 months. Here are some signs of head and
cutter wear, indicating that replacement is needed.
Irritation
As the heads get excessively worn there may be some
skin irritation. This would be especially noticed when
applying after shave lotion.
Pulling
When the cutters wear you may feel a sense of pulling
and a loss of closeness when you shave. This is an
indication that it is time to replace your heads and
cutters.
The replacement part for this shaver is model #SP-21. U.S.
residents: To order, contact us at 800-736-4648, visit us at
www.remington-products.com or visit your local retailer.
Canadian residents: For any shaver accessory requirements, please
call (800) 268-6531 or write: Remington Products
(Canada) Inc., P.O. Box 601, Postal Station “T,”Dept. A-100,
3019 Dufferin St., Toronto, Ontario, Canada M6B3T7.
CS27661_R-9170_series_IB_r1 9/1/05 11:01 AM Page 10