A SERVICE OF

logo

1. Pull trimmer release button down to engage trimmer. (Diagram F)
2. Trim long, difficult hairs and side burns. (Diagram G)
3. Close trimmer by pressing down on trimmer housing. (Diagram H)
7
Ensure your skin is dry and free of oils.
Wait at least 15 minutes after getting up before shaving, to ensure your face is
free of puffiness that may be present from sleeping.
Always hold the shaver at a right angle to the skin so that all three heads are
touching the skin with equal pressure.
Stretch skin with the free hand so hairs stand upright, making it easier for them
to enter the cutting chamber.
Use moderate to slow, circular stroking movement.
The use of short, circular motions in stubborn areas may obtain a closer shave,
especially along the neck and chin line.
Do not press hard against the skin in order to avoid damage to the rotary heads.
**Remington recommends that you use your new shaver daily for up to four
weeks to allow time for your hair and skin to become accustomed to the
new shaving system**
6
Shaving Tips
Trim
Cleaning & Care
Daily:
1. Press the hairpocket release button to open hairpocket assembly. (Diagram I)
2. Tap out excess hair shavings. (Diagram J)
3. Close hairpocket assembly. (Diagram K)
Monthly:
1. Perform daily cleaning tasks 1 and 2 first.
2. Remove the cover from the hairpocket assembly. (Diagram L) Place the body of
the shaver aside to ensure that it will not get wet.
3. Place a drop of liquid soap on the underside of the hairpocket assembly cover.
(Diagram M)
4. Brush the soap around vigorously. (Diagram N) Then rinse and dry the cover
thoroughly.
I J
K
L
M
N
O
P
F
G H
Q
R S T
U
To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
Ensure that the main body of the shaver remains dry at all times.
NOTE:
**When cleaning your shaver, make sure the shaver is turned off and
disconnected from the power cord.**
CAUTION!
To clean the external surfaces of the shaver, use a damp cloth. Do not use strong
detergents or other chemicals.
35887_R-3130-3135_IB.indd 6-7 3/26/08 9:50:46 AM