Filter
Top Products
Cleaning your shaver:
TO ASSURE SMOOTH, EFFICIENT PERFORMANCE,IT IS
IMPORTANT TO CLEAN YOUR SHAVER. Cleaning your
Remington
®
MicroScreen
®
2 Shaver is easy.
■ After each shave, remove the shaver head by squeez-
ing on both release buttons and pulling up from the body
of the shaver. Blow out the stubble thoroughly.
Important: Never clean the foil with the enclosed brush
because damage may occur to the holes in the foil.
■ At least once a week, the cutters
and the trimmer should be
cleaned with the cleaning brush.
Attention: Never put the shaver in
part or completely into water. Do not
use an aggressive cleansing agent as this may destroy
the shaver coatings.
■ Daily cleaning of the cutting system is recommended
to ensure optimum shaving performance. To clean and
lubricate your shaver's cutters and head assembly, apply
Remington
®
Shaver Saver
®
Lubricant (SP-4).The lubri-
cant helps remove hair clippings while reducing wear. A
quick spray after each shave keeps your shaver operat-
ing at peak performance.
Caution: Do not remove or replace the head assembly
while shaver is running as it may cause damage to
the unit's foils or cutters.
■ Worn or damaged parts should be replaced with
Remington
®
replacement parts only.
Trimmer Care
The trimmer on your Remington
®
MicroScreen
®
2 TCT
®
Shaver is
easy to maintain.
■ To clean the trimmer, you must first turn the shaver off, and
extend the trimmer to its maximum height (trimmer setting #3).
Then, just brush off any clippings that may accumulate around the
trimmer assembly. Using the brush supplied will enable you to get
into the area between the trimmer and the shaver.
■ Every six months lubricate the trimmer by applying a drop of
light machine oil one-third and two-thirds of the way along the
blade. Using your fingertip, spread the oil along the teeth, and run
the trimmer for a few seconds.
Replacing Screens and Cutters
Because they are subject to daily use, the cutters and foils of your
Remington
®
MicroScreen
®
2 TCT
®
Shaver will wear and eventually
require replacement to maintain a close, comfortable shave.
Depending on your shaving technique and habits, the foils will
usually last six months; the cutters, one year. Some signs that your
foils and cutters need replacing are:
■ Irritation. As foils get worn, you may notice that your skin feels
more sensitive after a shave, particularly when you apply aftershave.
■ Pulling. As cutters wear, your shave may not feel as close and
you may feel your shaver is pulling at your whiskers.
■ Wear-through. You may notice that the cutters have worn
through the foil.
To prevent inadvertent damage to the Screen and Cutter
Assembly, do not attempt to remove them unless you are
replacing them. To remove the old screens and cutters follow the
instructions that come with the screen and cutter replacement
package. It’s always a good idea to replace the screens when you
replace the cutters.
To Replace a Cutter Assembly That is
Removed Unintentionally:
■ Hold the assembly in the middle of
the "T".
■ Gently slide the plastic portion of the cutter
assembly over the top of the oscillator tip.
■ Do not push downward on the ends of the cut-
ters,as you may bend the cutter, reducing its ability to operate
smoothly.
■ Do not remove cutters from the plastic pieces to which they are
attached, as you may damage the assembly.