Remington MicroFlex 600 Electric Shaver User Manual


 
6
Getting a Close,
Comfortable Shave
Remington
®
brand shavers need no
adjustments to their heads or cutters
before you shave. The heads will
automatically adjust to the contours of
your face. It is not necessary to apply
pressure while shaving, just let the
shaver glide lightly on your skin. This
gentle touch makes shaving easier and
helps avoid possible skin irritation.
As with every shaver, your shave will
improve over time. So allow about three
weeks to develop an effective shaving
style and for your beard to adjust to the
new shaver.The adaptation period may
take a little longer if your skin is sensi-
tive, or if you alternate between shaving
methods.
It’s simple to get a great shave from
your new shaver. Here are a few tips:
Always use a clean,
dry shaver. Make
sure that the cutter
head assembly is in
the locked position.
Wait at least 15
minutes after getting
up before shaving, to
ensure your face is
free of puffiness that
may be present
from sleeping.
Make sure your face
is clean and dry
before starting.
To shave
Push the ON/OFF
button to activate
the shaver for
shaving.
Hold the shaver so
all the heads touch
your face together.
This allows the
shaver to work the
way it was designed
for the closest
shave and minimum wear.Avoid
holding the shaver at an angle so
only one head touches the skin.
This could cause skin irritation.
Use short, circular
strokes. Use your
free hand to stretch
your skin. This
encourages your
whiskers to stand
out, making it
easier for them to
enter the cutting chamber.
Never press hard. Pressing only
flattens your whiskers, which
makes it harder for them to enter
the cutting chamber. It will also
wear out the cutting surface
more quickly.
To trim
To use the Easy-
View
pop-up
trimmer, simply
push the trimmer
button up. The
trimmer will pop up
for ready use. Hold the shaver as
shown in the illustration. To conserve
battery energy (on rechargeable
shavers only), it is recommended to
use the trimmer only when needed for
trimming. When through using, push
the trimmer button downward to lock
into the OFF position.
NOTE: It is important to always
use the button to close the trimmer
to avoid damaging the locking
mechanism.
Trim sideburns
Simply touch the
edge of the trimmer
to the desired line
for neat, clean
sideburns.
Trim mustache
Hold shaver at
desired trim line
for a quick, easy,
professional trim.
The trimmer can
also be used to trim
the upper edge
of your mustache.
! Always keep the protective head
guard on the shaver head and keep
the trimmer in the OFF position when
the shaver is not in use.
6
12
9
3
Before using read the important
safety instruction section in front
of the manual.
To Charge
Before using your shaver for the first
time, charge it for 24 hours.
Slide the ON/OFF button to the OFF
position.
Connect the cord to the shaver
and then to the electrical outlet.
The Charging Indicator light will
glow green, indicating your
shaver is charging.
Your shaver cannot be over-
charged, so you can leave
it plugged in and charging
between shaves.
Use only the supplied cord.
The R-600 & R-650 fully recharges in
24 hours.
Once fully charged, your shaver will
run up to 60 minutes without a cord.
The R-650 has corded & cord free use.
NOTE: It may take up to 3 cycles of full
charge and discharge to maximize
battery capacity.
7
Operating Instructions
This is a washable
shaver, the head
assembly part
of which may be
cleaned under water.
30689_R-600/650_IB 8/24/06 2:42 PM Page 6