Filter
Top Products
9
Maintenance and Storage
8
Usage Tips
How to Get Professional
Results with Your Curling Iron
This unique curling iron has been designed
with multiple temperatures, providing very
high heat in the Hl (25-30) settings for curl-
ing very coarse, thick, hard-to-curl hair; and
very low heat in the LO (1-6) settings for
curling extra fine, damaged or dry hair. It
also provides a full range of heat settings
between LO and HI, for all normal
textures and thicknesses of hair.
TEST A SMALL SECTION OF HAIR BEFORE
USING; THEN ADJUST TEMPERATURE
DEPENDING ON HAIR TYPE.
Heat Settings
HI (25-30)
These settings are very hot. Use only if hair
is very coarse and highly resistant, but in
good condition.
MED/HI (19-24)
Use heat settings in this range for dense,
hard-to-curl hair in good condition.
MEDIUM (13-18)
Use heat settings in this range for thick,
wavy hair in good condition.
LO/MED (7-12)
Use heat settings in this range for easy-to-
curl, normal hair.
LO (1-6)
Use LO heat setting for very fine, fragile,
light-colored hair.
Styling
1.
Start by dividing hair into sections not
more than 1 inch deep and 2 inches wide.
2. Keep the section smooth by brushing or
combing through it while
holding the ends
taut with the other hand.
3. Taking one section at a time, place the
ends of hair over the barrel with the
clamp open. Then close the clamp,
making sure that the ends extend just a
tiny bit beyond the clamp.
4. Grasp the safety tip with the other hand,
and it will be easy to roll hair.
5. Keep the section of hair taut as you wind
it around the hot barrel. Wind the curl
toward the scalp as far as you wish to go
without touching scalp with the hot barrel.
6.
Hold the curl in place for up to 20 seconds
for tight curls or if hair is hard to curl.
Hold for less time if hair is easy to curl,
or if you want loose curls or just waves.
7. When ready to release curl, unwind
about half a turn (for longer hair, unwind
a bit more) and push down on the clamp
release lever to open the clamp. Now,
gently withdraw the barrel from the cen-
ter of curl. Allow curl to cool, and try not
to disturb curls while proceeding in the
same manner around whole head.
8. When completely finished, and all curls
have cooled thoroughly, gently brush and
comb hair into the style desired.
For a Flip, the clamp should be under and
the barrel over the section of hair at the
start of the curl.
For a Curl, the clamp should be over and
the barrel under the section of hair at the
start of the curl.
For Volume and Body, roll hair loosely
around the barrel. Allow hair to cool slightly
before brushing.
Maintenance
■ To clean the unit, be sure the unit is
cool and unplugged. Wipe the handle
and barrel with a damp cloth. No other
maintenance is necessary.
■ Do not attempt to repair the appliance
yourself.
Storage
When not in use, unplug the unit. Allow it
to cool, and store it out of reach of children
in a safe, dry location.
Never wrap the cord around the appliance
as this will cause the cord to wear
prematurely and break, thus voiding
warranty. Handle cord carefully for long
life, and avoid jerking, twisting or straining
it, especially at plug connections.