Filter
Top Products
7
6
How to Use
Line Cord Safety Tips
■ To insert plug, grasp it firmly and guide
it into outlet.
■ The appliance has a polarized plug , so it
will only fit into the outlet one way. (See
safety warnings for more details.)
■ To disconnect the appliance, grasp the
plug and remove it from outlet. Do not
pull or yank on the cord
or appliance.
Do not wrap the cord around the
appliance.
Note: Before each use, inspect the line
cord for cuts and/or abrasion marks.
DO NOT OPERATE THE APPLIANCE IF
THE LINE CORD SHOWS ANY DAMAGE.
Important
During the first few minutes of initial use,
there may be a slight odor. This is normal
and will quickly disappear.
Heat Cautions
This multi-temperature curling iron has
been specially designed to be able to curl
very coarse, thick, hard-to-curl hair. Due to
this special application, the barrel of this
curling iron will be hotter on the HI (25-30)
settings than regular dual-heat curling irons.
Due to the extreme capabilities of this
iron, the barrel will be very hot in the HI
(25-30) settings, so extra care should be
taken when using.
■ Keep unit away from contact with all
skin areas. Do not touch barrel with
fingertips.
■ For shorter hair, place a thin plastic
comb between scalp and curling iron
barrel to avoid touching scalp.
■ Place fingers of free hand on safety tip
when you need more control for curling.
■ Test a small section of hair to determine
correct heat setting for your hair type.
Special Reheating Feature
This iron features solid-state electronic
circuitry with a heat sensor that detects
temperature loss and quickly boosts the
power to bring the heat level back to
optimum styling temperature. During use
the indicator light will repeatedly go
through cycles of flashing and becoming
steady as the appliance is constantly
bringing itself back to optimum styling
temperature.
Auto-off
After approximately one hour, the unit will
automatically shut itself off. To reactivate
the unit, press the ON/OFF switch.
Dual Voltage Use
This appliance contains a special electronic
circuit that automatically converts it for
worldwide usage–from 100 to 240 volts
AC, 50 to 60 Hz. Just plug it into the local
outlet and use it as normal; the styler will
automatically adjust to the local current.
(You may need an adapter to allow the plug
to fit into the local outlets, however.)
How to Use
Hair should be clean, dry or nearly dry, and
free of tangles before using. (This iron can
also be used for quick touch-ups any time.)
1. Rest the iron on its stand on a smooth,
flat surface, and plug it in.
2. Press the ON/OFF switch, and the power
indicator light will flash.
3 Select a temperature according to
the type and texture of your hair.
4. With the heat control dial set at the
desired setting, allow the unit to
pre-heat. The power indicator light
will begin to flash, signaling that the
appliance is heating up. When the
appliance is heated the indicator
light
will glow steadily.