Filter
Top Products
8 9
Taking a Reading
NOTE: Many pediatricians recommend the use of ear thermometers for children
older than 6 months.
1. Press and release the SCAN button. After two seconds,
the system will perform a self-test,
Fig. 1, and show the
last temperature taken along with a flashing “°F” to indicate
the unit is ready for measurement,
Fig. 2.
2. Gently insert the probe snugly into the ear canal until a
slight resistance is felt. The thermometer will beep when
the auto-position sensor detects proper placement. If the
unit does NOT beep, gently reposition the thermometer.
NOTE: To disable the auto-position sensor, immediately press
the SCAN button after inserting the thermometer into the ear
canal.
3. After the unit beeps, press the SCAN button,
Fig. 3, and
promptly release the button. The device will beep once
again after the measurement is complete.
NOTE: If you do NOT press the SCAN button once it is
placed in the ear canal, the thermometer will automatically
take a measurement in 9 seconds.
4. If the measurement is below 100.4°F (38°C), the
thermometer will beep once and the measurement will be
shown on the display with a happy face symbol,
Fig. 4.
5. If the temperature is 100.4°F (38°C) or above, the thermometer will sound
one long beep followed by two short beeps. The measurement will be shown
on the display with a sad face symbol to indicate fever,
Fig. 5.
6. Thermometer will automatically beep and shut off after approximately 1
minute of non-use.
NOTE: To ensure accuracy,
1. Please wait at least 10 seconds between successive readings.
2. Clean the probe lens before and after each use.
Fig. 2
Fig. 1
Changing Modes
Temperature readings can be displayed in either Fahrenheit
or Celsius. To switch between °F or °C, press and hold the
SCAN button. Without releasing, also press the ‘M’ button
and toggle between the modes,
Fig. 1 and 2.
Recalling Measurements in Memory
The last 10 measurements taken are automatically
stored into memory. To recall measurements, press
the SCAN button to turn the unit on. After the unit
beeps, press the ‘M’ button to view measurements in
memory. Continue to press the ‘M’ button to view the
next previously stored measurement,
Fig. 1. The unit
will beep each time a recorded measurement is viewed.
Replacing the Battery
Your Instant Ear Thermometer requires one lithium battery, type CR2032.
The battery needs to be replaced when the low battery symbol appears
on the display.
To replace the battery:
1) Slide the battery cover off.
2) Using a non-metal pointed tool, carefully
remove the battery and insert the new battery
with the positive (+) side facing up.
3) Replace the battery cover.
NOTE: Please properly dispose the battery away
from small children and heat.
Fig. 1
Fig. 2
Memory
Symbol
Index
Fig. 1
Fig. 3
Fig. 4
Fig. 5