Razor E175 Mobility Scooter User Manual


 
6
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code located on the white label on your product or back of charger available for better assistance.
4 Remove wheel and install
replacement wheel.
(Note the sequence of the
hardware)
5 Push the chain tensioner
down to install the chain on
both sprockets.
6 With two 13 mm open
wrenches, re-tighten the
locknuts.
Note: Rear wheel hardware
sequence
Right Side (Throttle)
18-1 13 mm Locknut
18-7 Spring Washer
18-2 Washer
Frame
18-3 Washer (Plate Cut)
18-4 Spacer (Short)
Left Side (Brake)
18-1 13 mm Locknut
18-7 Spring Washer
18-2 Washer
Frame
18-3 Washer (Plate Cut)
18-4 Spacer (Long)
7 Re-attach the chain guard.
q Battery Care and Disposal
Do not store in freezing or below freezing temperatures. To properly maintain your battery and ensure maximum battery
life, carefully read the “Charging the Battery” section on page 3 of this owner’s manual.
CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUST BE RECYCLED.
Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an
environmentally safe manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak.
Do not dispose of a lead-acid battery in your regular household trash. The incineration, land filling or mixing of sealed
lead-acid batteries with household trash is prohibited by law in most areas. Return exhausted batteries to a federal or
state approved lead-acid battery recycler or a local seller of automotive batteries. If you live in Florida or Minnesota, it
is prohibited by law to throw away lead-acid batteries in the municipal waste stream.
q Charger
The charger supplied with the electric scooter should be regularly examined for damage to the cord, plug,
enclosure and other parts. In the event of such damage, the product must not be charged until it has been
repaired or replaced.
Use ONLY the charger supplied with this product or a replacement specified by Razor.
q Wheels
Wheels and drive system are subject to normal wear and tear. It is the responsibility of the user to periodically inspect
wheels for excess wear, and to adjust and replace drive train components as required.
q Replacement Parts
For the complete selection of replacement parts visit www.razor.com.
q Repair Centers
For a list of authorized Razor repair centers:
• Check online at www.razor.com.
• Call 866-467-2967 for the center nearest you.
WARNING: If a battery
leak develops, avoid any contact
with leaking acid and place the
damaged battery in a plastic bag.
Refer to the disposal instructions at
left. If acid comes into contact with
skin or eyes, flush with cool water
for at least 15 minutes and contact
a physician.
WARNING: Battery
posts, terminals and related
accessories contain lead and lead
compounds. Wash your hands
after handling.
REPAIR AND MAINTENANCE
REPAIR AND MAINTENANCE
18-1
18-7
18-2
18-3
18-4
18-4
18-3
18-2
18-7
18-1
Middle
18-8 Rear Axle Bolt
18-8