Filter
Top Products
CONNECTORS/HARDWARE MAINTENANCE
Safety Gear
Always wear proper protective gear such as an approved safety
helmet. Elbow pads and kneepads are recommended. Always
wear athletic shoes (lace-up shoes with rubber soles), never ride
barefooted or in sandals, and keep shoelaces tied and out of the
way of the wheels, motor and drive system.
Battery
Make sure the power switch is turned off whenever the scooter is
not in use. Never store the product in freezing or below freezing
temperatures! Freezing will permanently damage the battery.
Recharge the battery at least once a month when scooter is not
in use.
Brake
Check the brakes for proper function. When you squeeze the lever,
the brake should provide positive braking action. When you apply
the brake with the speed control on, the brake cut-off switch
should stop the motor. Make sure that brakes are not rubbing.
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken frames
are rare, it is possible for an aggressive rider to run into a curb
or wall and wreck and bend or break a frame. Get in the habit of
inspecting your scooter on a regular basis.
Tires
Periodically inspect the tires for excess wear and regularly check
the front tire pressure and re-inate as necessary.
q
q
q
q
q
Do not use this product for the first time until you have inflated
the front tire to the correct PSI and charged the battery for at
least 12 hours. Failure to follow these instructions may damage
your product and void your warranty.
ASSEMBLY AND SET-UP
q Installing Spark Bar
5
1 Using two (2) 5mm Allen
wrenches remove the coupling
bolt that is attached to the end
of the metal bar of the Spark
Bar. Slide the Spark Bar onto
the metal bar located on the
opposte side of the chain. Push
down on the Spark Bar and slide
the bar all the way on until the
holes are aligned.
2 Re-insert the coupling bolt
through the metal bar and
tighten until Spark Bar is locked
securely in place.