Quantum Quantum R-4400 4MP Wheelchair User Manual


 
26 www.pridemobility.com Quantum R-4000
Controller Position
You can move the controller in toward or out away
from the armrest, or change the position of the control-
ler for either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 19.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or TRU-Balance Power
Positioning System, loosen the setscrews in the
mounting block, slide the controller in or out to the
desired position, then tighten the setscrews. See fig-
ure 20.
To change the controller position:
1. Turn off the power to the controller.
2. Release the battery door latches and open the bat-
tery door if necessary.
3. Unplug the controller connector from the power base.
4. Remove any wire ties securing the controller harness
to the armrest.
5. Flip up the armrest so it is perpendicular to the floor.
6. Loosen the setscrew on the controller bracket.
7. Slide the controller out of the armrest.
8. Loosen the setscrew in the other armrest.
9. Place the controller in the other armrest.
10. Tighten the setscrew to secure the controller.
11. Route the controller harness to the front or back of
the power base and plug in the controller. See fig-
ure 6 or 7.
12. Close the battery door and secure the latches if nec-
essary.
13. Secure the controller harness to the armrest with
wire ties. See figure 14.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or TRU-Balance Power
Positioning System, loosen the mounting screws in
the mounting block, transfer the mounting block and
controller to the opposite armrest, and tighten the
mounting screws. See figure 20 .
V. COMFORT ADJUSTMENTS
Figure 20. Adjusting Controller Position (Standard Seat)
SETSCREWS
MOUNTING SCREWS
MOUNTING BLOCK
Figure 19. Underside of Armrest
SETSCREW
CONTROLLER BRACKET