Filter
Top Products
17
T2:Wait
The output of Channel 2 can be delayed for a number of pulses. This menu is used to set the
number of pulses that must occur on the other channels before the output of Channel 2 is en-
abled. This is particularly useful when using Channel 2 as a Q-switch trigger, as it allows the
laser to thermally stabilize before activating the Q-switch.
This function is active only in Continuous, Burst, and Duty Cycle modes. Channel 2 is delayed
at the start of each burst in the Burst mode or at the start of each cycle in the Duty Cycle
mode.
T2*n - T2 Period Factor
The period at which Channel 2 (T2) is pulsed can be set to be a multiple of the other channels.
This menu item is used to select the multiplier. For example, if the To period ToPer) is set to
.100 sec (10Hz), setting T2*n to 2 will cause the channel 2 period to be .200 sec (5Hz).
Store/Recall/Misc. Menus
The 9412/9412A contains non-volatile memory for storing four (4) (eight (8) for the 9412A)
different configurations. The settings of all menu selections are stored and can be quickly re-
called.
STORE Configuration
Stores the current menu settings in the specified memory location (one (1) - four
(4) (eight (8) for 9412A).
Note: If you overwrite a particular location, its previous contents are destroyed.
To store a configuration use the Up and Down arrow keys to select the memory location
number and press the Left or Right arrow key. You will be prompted to press the key to
verify that you want to overwrite the existing stored configuration. If you press any other key,
the configuration will not be saved.