Quantum 1121 3MP Wheelchair User Manual


 
Quantum 1121 Series www.pridemobility.com 19
To install the seat:
1. Set the seat towers to the desired height. To change
the seat height, see V. “Comfort Adjustments.”
2. Tilt the seat back, and slide the rear extrusion onto
the rear trapeze bar.
3. Lower the front extrusion onto the front trapeze bar
until the seat latches into place.
4. Flip the seat latch safety down.
WARNING! Make sure the seat latch
safety is flipped down before using
your power chair.
5. Install the controller into one of the armrests. See V.
“Comfort Adjustments.”
6. Plug the controller harness into the connector on the
electronics tray.
7. Route the harness to ensure that the harness cannot
be pinched in the seat hinge. See figure 11 or 12.
8. Secure the controller harness to the armrest receiver
with one or more wire ties.
MANDATORY! Prevent controller
harness damage! Avoid routing the
controller harness on the outside of the
armrest pad. Route the harness under
the armrest or toward the inside of the
armrest pad. Use correct tie-down
points for the controller harness to
prevent the harness from getting
caught in the drive tires, pinched in the
seat frame, or damaged when passing
through doorways.
IV. ASSEMBLY
Figure 11. Controller Harness Routing – Contour Seat
Figure 12. Controller Harness Routing – Synergy Seat
WIRE TIES