Filter
Top Products
30 www.quantumrehab.com Quantum 1107
V. COMFORT ADJUSTMENTS
To change foot plate tilt (C):
1. Loosen the hardware.
2. Tilt the foot plate to desired position.
3. Tighten the hardware.
To change foot plate angle (D):
1. Turn the setscrew clockwise to decrease the angle.
2. Turn the setscrew counterclockwise to increase the angle.
NOTE: Each drive tire must be inflated to 35 psi (2.4 bar) if equipped with pneumatic tires. The user must also
be seated in the power chair in order to properly adjust the anti-tip wheels.
To adjust the anti-tip wheels:
1. Loosen nut A. See figure 27.
2. Remove bolt B.
3. Raise or lower the anti-tip wheel. Each hole is 1/2-in. apart.
4. Reinstall bolt B.
5. Tighten nut A.
6. Raise or lower the other anti-tip wheel so that it is at the same height.
NUT A
BOLT B
Anti-Tip Wheels Adjustment
The anti-tip wheels are designed to give your power chair
increased stability on rough surfaces. The anti-tip wheels are
preset at the factory for smooth surfaces or indoor use only.
If you plan on using your power chair on rough surfaces, it
may be necessary to adjust the anti-tip wheels to better suit
your needs. The anti-tip wheels may need adjustment if the
following occurs:
! When coming to a stop, your power chair tips forward excessively.
! The anti-tip wheels constantly rub the ground.
WARNING! Consult your Quantum Rehab Specialist before attempting to change the anti-tip wheel
height! Changing the anti-tip wheel height affects handling under acceleration!
WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair’s
tendency to tilt forward while decelerating. You can compensate for this by having your Quantum
Rehab Specialist make a small adjustment to the pre-programmed deceleration setting in the
controller or by moving the seat assembly farther to the back of your power chair.
PROHIBITED! Do not remove the anti-tip wheels.
To change foot plate position (B):
1. Remove the hardware.
2. Move the foot plate to the desired position.
3. Reinstall the hardware.
Figure 27. Anti-Tip Wheel Assembly