Filter
Top Products
Quantum 1103 Ultra www.pridemobility.com 27
Controller Position
You can move the controller in toward or out away
from the armrest, or change the position of the control-
ler for either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the
floor.
2. Loosen the setscrew on the controller bracket. See
figure 19.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the
rear shroud.
3. Unplug the controller connectors from the power
module.
4. Cut the wire ties that attach the controller harness
to the armrest.
5. Flip up the armrest so it is perpendicular to the
floor.
6. Loosen the setscrew on the controller bracket. See
figure 19.
7. Slide the controller out of the armrest.
8. Loosen the setscrew in the other armrest.
9. Place the controller in the other armrest.
10. Tighten the setscrew in each armrest.
11. Route the controller connector to the back of the
power base and secure the controller harness to the
armrest receiver with wire ties.
12. Plug the controller connectors into the power
module. See figure 7.
13. Reinstall the rear shroud and tighten the fasteners.
NOTE: If your power chair is equipped with a Specialty
Seat, Synergy Seat or TRU-Balance Power Positioning
System, refer to the information provided in supple-
mental manuals provided with your seating system.
V. COMFORT ADJUSTMENTS
Figure 19. Underside of Armrest
SETSCREW
CONTROLLER BRACKET