Filter
Top Products
14 www.pridemobility.com Q6 Edge VA
IV. ASSEMBLY
MANDATORY! Prevent controller
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for controller harness to
prevent the harness from getting
caught in the drive tires, pinched in the
seat frame, or damaged when passing
through doorways.
5. Plug the controller connector into the rear of the
power base. See figure 3.
6. Secure the controller harness to the armrest
receiver with wire ties. See figure 10.
To install the seat (Transit Securement System):
1. Attach the seat plate to the four mounting brackets
on the power base and ensure all hardware is prop-
erly installed and tightened securely. See figure 9.
2. Install the controller and route the harness to the
back of the power. See figure 10.
MANDATORY! Prevent controller
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for controller harness to
prevent the harness from getting
caught in the drive tires, pinched in the
seat frame, or damaged when passing
through doorways.
Figure 9. Seat Installation—Occupied Transit
Figure 10. Controller Harness Routing on a Contour Seat
WIRE TIES
TO POWER BASE
SEAT PLATE
HARDWARE
MOUNTING
BRACKETS
HARDWARE