Filter
Top Products
Signal Manager
Advanced “Drag and Drop” Software Configuration
DSP configuration is made simple with a PC-based “drag-
and-drop” software program called Signal Manager. Users
can access a DSP “toolbox” and simple drawing tools
to configure processing functions and signal flow. DSP
processing power and memory is dynamically assigned
to signal processing functions and any combination of
functions may be configured until the total capacity is used.
DSP resources are graphically displayed at the bottom of
the screen.
Configurations can be downloaded directly to the DSP-4
via an RS-232 serial port or through a QSControl Audio
Network System via a CM16a Amplifier Network Monitor for
added simplicity. The software package also offers real-time
control and set-and-forget convenience. Configurations can
be saved and recalled for future use.
The DSP is configured with an
easy-to-use software interface.
Signal processing icons from the
toolbar are dropped onto the
workspace and the signal path is
routed with simple drawing tools.
Compatible Amplifier Models
The DSP-4 mounts directly to the back of these models via the DataPort:
Full Feature Version 2 DataPort
• Two-channel CX Series • ISA
(V2 DataPort – audio only;
• Two-channel DCA Series
• PowerLight 2 Series
The following models require a Remote Rack Mounting Bracket:
Full Feature (DPX-2 cable required) Reduced Feature Set
• 4-channel CX Series • MX • Non-QSC amplifiers
• 4-channel DCA Series • USA
• PowerLight Series • PLX
• 8-channel CX Series • RMX
Configurations
requires external power supply)