Filter
Top Products
29
Rally Shopper
VII. OPERATION
GETTING OFF OF YOUR SCOOTER
1. Bring your scooter to a complete stop.
2. Remove the key from the key switch.
3. Push forward on the seat lock lever and rotate the seat until you are facing toward the side of your scooter.
4. Make certain that the seat is locked securely in position.
5. Unfasten the positioning belt, if equipped.
6. Carefully and safely get out of the seat and stand to the side of your scooter.
7. You may, if you wish, leave the seat facing to the side to facilitate boarding your scooter next time.
AUTO SHUTOFF FEATURE
The scooter is equipped with an energy saving auto shutoff feature.
n If you leave the key in the on position and the scooter remains inactive for approximately 20 minutes, the
electronic controller assembly will automatically shut down. This feature is designed to preserve battery life.
NOTE: Although the electronic controller assembly will be shut down by the auto shutoff feature, all
activated lights will remain on. For maximum battery life it is recommended that you turn off your lights
or turn the key to the off position.
To restore power back to the scooter:
n Turn the key counterclockwise to the off position.
n Turn the key clockwise to the on position.
Your scooter will now resume normal operation.
WARNING! Never attempt to get off of your scooter without first removing the key from
the key switch. This prevents the scooter from moving if accidental throttle control lever
contact is made.
SEAT SAFETY PRESSURE SWITCH
The seat is equipped with a safety pressure switch located inside the seat cushion and is activated by the weight of
a user. See figure 14.
When the user is seated, the scooter will operate normally. If the user stands or leans and enough weight is taken
off the seat safety pressure switch, the scooter will come to a stop and not move again until the user is firmly
seated.
NOTE: The safety pressure switch harness extending from the seat bottom must be connected to its mating
plug that extends up and along the seat post or the scooter will not move.
CAUTION! The safety pressure switch harness MUST be disconnected before removing
the seat from your scooter or damage to the harness will occure. See figure 14.