Filter
Top Products
15Shuttle
REAR
DOOR
CHARGER CORD
MAIN CIRCUIT BREAKER
BATTERY CONNECTORS
AMMETER
FIGURE 8. REAR SECTION
MANUAL FREEWHEEL LEVER
ANTI-TIP WHEEL
FIGURE 8A. REAR SECTION
MOTOR TRASAXLE
ASSEMBLY
V. DESCRIPTION
REAR SECTION
The onboard battery charger (not shown), the charger cord, the battery charger fuse (not shown), the batter-
ies, the electronic controller assembly, the main circuit breaker, the manual freewheel lever, the anti-tip wheels,
and the motor/transaxle assembly are located on the rear section of your Shuttle. See figures 8 and 8A.
Onboard Battery Charger (not shown)
The onboard battery charger converts household current (AC) to direct current (DC) and charges the batter-
ies of your Shuttle. See VI. Batteries and Charging.
n The charger is located behind the batteries and at the forward right corner of the rear section.
n The charger is a box with cooling fins on the exterior of its case.
Ammeter and Charger Cord
On the rear shroud, above the chrome bumper, is a compartment door secured by a black rubber latch.
Inside this compartment is the charging ammeter and power cord for the scooters onboard charger.
NOTE: The ammeter is operational only when the charger power cord is plugged into a standard wall
outlet.
Battery Charger Fuse (Not shown)
The fuse has been incorporated into your charger to protect it from damage in the event of an electrical
problem.
CAUTION! The replacement fuse must match the rating of the original fuse exactly. If you
install a fuse with an incorrect rating, you may damage the charger. Contact your local
Pride provider for fuse rating information.
Batteries
The batteries store the electrical energy that powers your Shuttle. See VI. Batteries and Charging.
BATTERIES