Filter
Top Products
24 www.quantumrehab.com Quantum 1122 Series
V. COMFORT ADJUSTMENTS
10. Move the seat towers up or down to the desired height.
11. Reinstall the ball detent pin into each seat tower.
12. Reinstall the shroud.
13. Reinstall the trapeze bars and secure with the quick-
release pins.
14. Reinstall the seat.
WARNING! Make sure the seat latch
safety is flipped down before using the
power chair.
15. Plug the controller connector(s) into the electronics tray.
Seat Position
You can move the seat forward or rearward by changing
the extrusion mounting position.
To change the seat position:
1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the electronics
tray.
3. Remove the seat from the power base.
4. Remove both extrusions from the bottom of the seat.
5. Reposition the extrusions on a different set of mount-
ing holes. You must move both extrusions the same
number of holes either forward or backwards. See
figure 14.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Plug the controller connector(s) into the electronics tray.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release le-
ver. The lever is located on the right side of the seat base.
To adjust the seatback angle:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired position.
3. Release the lever.
Headrest Height Adjustment
If your power chair is equipped with an optional deluxe
high-back seat, you can adjust the headrest height.
Figure 14. Seat Position Adjustment