Filter
Top Products
16 Basic Operation Instructions
Synergy TRU-Balance Power Recline www.quantumrehab.com
POWER SEAT ELEVATOR OPTION
The power seat elevator provides lift of up to 7 in. (18 cm) from the power base
using a single post plate and actuator. See figure 9. The maximum weight capacity
of the power seat elevator is 300 lbs. (136 kg) and is available on some models.
Contact your Quantum Rehab Specialist for specific information. The power seat
elevator operates through the power chair controller, toggle switch, or Attendant
Control Module.
NOTE: When the seat is elevated, a 1/4-speed drive inhibit is engaged and
you are no longer able to tilt the seat. See figure 2.
NOTE: Operation instructions using the joystick 4-way toggles are dis-
cussed below. If you are using a different toggle, the Attendant Control
Module, or a different operating device, please refer to the appropriate
section of this manual or the operation manual supplied with that device
and/or your power chair owner’s manual.
To operate the power seat elevator:
1. Push the toggle switch to the left to elevate the seat.
2. Push the toggle switch to the left, release, then push to the left again to
lower the seat.
Figure 9. The Power Seat Elevator Option on a Synergy TRU-Balance
Power Recline
Actuator