Filter
Top Products
Jazzy Select 14Series www.pridemobility.com 25
Controller Position
You can move the controller in toward or out away from the
armrest, or change the position of the controller for either
left-hand or right-hand use.
MANDATORY! Do not place the controller
cable so that it can be pinched in the seat
frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See figure 14.
3. Slide the controller into or out of the armrest to the de-
sired position.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector from the power base.
3. Remove any wire ties securing the controller cable to the
armrest.
4. Flip up the armrest so it is perpendicular to the floor.
5. Loosen the setscrew on the controller bracket
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Route the controller cable to the back of the power base
and plug in the controller.
11. Secure the controller cable to the armrest with wire ties.
NOTE: If your power chair is equipped with a Specialty
Seat, loosen the mounting screws in the mounting
block, transfer the mounting block and controller to
the opposite armrest, and tighten the mounting screws.
See figure 15.
V. COMFORT ADJUSTMENTS
SETSCREW
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several heights.
To raise or lower the foot platform:
1. Remove the hardware from the foot platform bracket as
shown in figure 16.
2. Reposition the foot platform to the desired height.
3. Reinstall the hardware.
Figure 15. Controller Position Mounting Bracket
SETSCREWS
MOUNTING
SCREWS
Figure 14. Underside of Armrest
Figure 16. Foot Platform Adjustment
FOOT PLATFORM BRACKET
ADJUSTMENT
SCREW