Filter
Top Products
26 www.quantumrehab.com Quantum 600 Series
V. COMFORT ADJUSTMENTS
Controller Position
You can move the controller in toward or out away from
the armrest, or change the position of the controller for ei-
ther left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 16.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or TRU-Balance Power Po-
sitioning System, loosen the setscrews in the mount-
ing block, slide the controller in or out to the desired
position, then tighten the setscrews. See figure 15.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear
shroud.
3. Unplug the controller connector from the power base.
4. Remove any wire ties securing the controller cable to
the armrest.
5. Flip up the armrest so it is perpendicular to the floor.
6. Loosen the setscrew on the controller bracket
7. Slide the controller out of the armrest.
8. Loosen the setscrew in the other armrest.
9. Place the controller in the other armrest.
10. Tighten the setscrew in each armrest.
11. Route the controller cable to the back of the power
base and plug in the controller.
12. Replace the rear shroud and tighten the fasteners.
13. Secure the controller cable to the armrest with wire ties.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or TRU-Balance Power Po-
sitioning System, loosen the mounting screws in the
mounting block, transfer the mounting block and con-
troller to the opposite armrest, and tighten the mount-
ing screws. See figure 15 .
Figure 15. Controller Position Mounting Bracket
SETSCREWS
MOUNTING
SCREWS
Figure 16. Underside of Armrest
SETSCREW
CONTROLLER BRACKET
+