Filter
Top Products
30 www.quantumrehab.com Quantum 6000Z Series
Figure 23. Swing-Away Footrests
ADJUSTMENT
SCREWS
FOOTREST
EXTENSION
SFR RELEASE LEVER
ADJUSTMENT
SCREWS
RELEASE LEVER B
Figure 24. Elevating Leg Rests
RELEASE LEVER A
LEG REST
EXTENSION
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-
quarter or one-half turn.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew. See
figure 22.
2. Loosen the nut securing the setscrew.
3. Turn the setscrew to raise or lower the front of the foot
platform.
4. Tighten the nut to secure the setscrew.
Swing-away Footrests
Swing-away Footrests (SFRs) enable you to rotate the foot-
rests to the side before you transfer onto or off or your power
chair. See figure 23.
To rotate the SFRs:
1. Push in the release lever.
2. Rotate the SFRs.
To adjust the SFR length:
1. Remove the two adjustment screws from the back of
each footrest extension.
2. Slide the footrest up or down to the desired length.
3. Reinstall the two adjustment screws.
Elevating Leg Rests (Optional)
Elevating Leg Rests (ELRs) offer an infinite range of ad-
justment for the leg angle and a footrest adjustment range
of 12–19 in. (30.48-48.26 cm). See figure 24.
To rotate the ELRs:
1. Push in release lever A.
2. Rotate the ELRs.
To adjust the ELR angle:
1. Push down release lever B.
2. Move the leg rest to the desired angle.
V. COMFORT ADJUSTMENTS
ADJUSTMENT BOLT
LEG REST ADJUSTMENT
SCREWS
Figure 25. Heavy Duty Drop-In Leg Rests
LEG REST
HANGER