Filter
Top Products
Jazzy 1170 XL Plus www.pridemobility.com 25
V. COMFORT ADJUSTMENTS
Anti-Tip Wheels
The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip wheels
are preset for smooth surfaces or indoor use only. If you plan on using your power chair on rough surfaces, it may
be necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may need adjustment if
either of the following occur:
! When coming to a stop, your power chair tips forward excessively.
! The anti-tip wheels constantly rub the ground.
WARNING! Consult your authorized Pride Provider before attempting to change the anti-
tip wheel height! Changing the anti-tip wheel height affects handling under deceleration!
WARNING! The higher you raise the anti-tip wheels, the more you increase your power
chair’s tendency to tilt forward when coming to a stop. You can compensate for this by
having your authorized Pride Provider make a small adjustment to the pre-programmed
deceleration setting in the controller or by moving the seat assembly farther to the rear of
your power chair.
PROHIBITED! Do not remove the anti-tip wheels.
To adjust the anti-tip wheels:
1. Place a wrench on the inner locknut of the anti-tip bracket located right in front the shock strut. See figure 18.
2. Turn locknut counterclockwise to loosen the cam.
3. Place your wrench on the adjustable camlocated on the other side of the locknut.
4. To adjust the anti-tip upward, turn the cam counterclockwise. To adjust the anti-tip downward, turn the
cam clockwise. See figure 19.
5. Tighten the locknut.
NOTE: Each drive tire must have 35 psi (2.4 bar) in order for the anti-tip wheels to be properly ad-
justed.
Figure 18. Anti-Tip Bracket (Inner Locknut)
Figure 19. Anti-Tip Wheel Adjustment (Cam)