Polycom 1725-36055-001 Mobility Aid User Manual


  Open as PDF
of 7
 
Cisco: 340 Access Point
PN: 1725-36055-001_G.doc
7
6. By default, WEP (Wired Equivalency Privacy) is off. If WEP is
desired, obtain the key values from the local administrator of the
wireless LAN and use the AP vendor documents for guidance in
programming the encryption settings.
Note the WEP settings. The handsets require configuration with
identical settings.
7. Navigate to
AP Radio > Hardware.
The following table shows additional settings:
Hardware Parameter Setting Criticality
Allow broadcast SSID to
associate?
Yes Recommended
Data rates: 1.0 Basic Required
2.0 Any Required
5.5 Yes or no Required
11.0 Yes or no Required
Transmit power 30 mW Recommended
Fragmentation threshold 584 or higher Required
Beacon period (Kusec) 100 Recommended
Data beacon rate (DTIM) 2 Recommended
Receive antenna Diversity Recommended
Transmit antenna Diversity Recommended
8. After these parameters have been set, click Apply to accept these
settings.
9. Return to the
Setup menu and select Advanced to the right of the AP
Radio
section at the bottom of the screen. It is recommended that
the
Use Aironet Extensions parameter be set to No.
10. Return to the
Setup menu and select Advanced to the right of the AP
Radio
section at the bottom of the screen. It is recommended that
the
Change Radio Preamble parameter be changed to Long.
11. The Cisco 340 Access Point has SpectraLink Voice Priority (SVP)
active at all times. There is no parameter to enable or disable.
12. Restart the AP.
The AP is now ready for use with SpectraLink 8000 Wireless
Telephones.
 previous