Filter
Top Products
31
En
Preparation
05
English
Connecting the power cord
Connect the power cord after all component connections have been completed.
Plasma Display (rear view)
NOTE
• Always turn off the power of the Plasma Display when
connecting or disconnecting power cords.
• Disconnect the power cord from the power outlet when the
Plasma Display System is not going to be used for a long
period of time.
Routing cables
Attaching speed clamps to the main unit
Attach the speed clamps using any of the 4 holes you prefer (50
inches, 3 holes; 42 inches, 2 holes) marked with below,
depending on your routing system.
for PDP-6072HD/PDP-6071HD/PDP-6070HD
for PDP-5072HD/PDP-5071HD/PDP-5070HD
for PDP-4272HD/PDP-4271HD/PDP-4270HD
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the Plasma
Display and snap [2] into the back of [1] to lock the clamp.
Speed clamps are designed to be difficult to undo once in
place. Please attach them carefully.
Use pliers to twist the clamp 90º, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
NOTE
• Use the supplied bead bands and speed clamps as
necessary.
• When tidying up your speaker cables, make sure to bundle
them so that they are not subjected to any pressure.
Power cord
AC IN terminal is located on the
upper edge of the compartment.
Noise filter
Partially eliminates noise
caused by the power source.
Rear view
Speaker cable
When the speaker is installed under the display panel o
f
the PDP-5072HD/PDP-5071HD/PDP-5070HD:
Bead band
1
2
CAUTION
• Use only the supplied power cord.
• Be sure to use the specified power supply voltage;
neglecting this can result in fire or electric shock.
• For the Plasma Display System, a three-core power
cord with a ground terminal is used for efficient
protection. Always connect the power cord to a
three-pronged outlet and make sure that the cord
is properly grounded.
PDP6070HD.book Page 31 Friday, May 19, 2006 5:01 PM