Filter
Top Products
- The Quadpacer® is an interval timer that has a short beep and pause
to remind you to brush the 4 sections of your mouth. Depending
on the brushing mode or brushing routine you have selected, the
Quadpacer beeps at different intervals during the brushing cycle.
See the “Brushing instructions” and “Personalizing your brushing
experience” sections.
The Quadpacer feature on this model has been activated. To deactivate or
reactivate the Quadpacer feature:
1 Place the handle with a brush head attached in the plugged-in
charger.
2 Press and hold the Personalized brushing button until:
A You hear 1 beep to indicate the Quadpacer has been deactivated.
B You hear 2 beeps to indicate the Quadpacer has been activated.
Note: The Quadpacer feature cannot be deactivated on the pre-programmed
Go Care and Max Care brushing routines.
If your model includes the deluxe charger cover and base, the travel
charger is pre-installed inside the cover. If you want to shorten the power
cord, you can store excess cord in the cord wrap feature built into the
charger base.
1 To separate the charger cover from the charger base, press the two
gray snap bars on the charger base and pull the white charger cover
upwards.
2 Wrap excess power cord around the gray charger base as shown in
the picture. Be sure to wrap the cord on the inside of the two snap
levers.
3 When you have stored the excess cord, guide the power cord
through the small groove in the rear of the gray charger base.
4 Reattach the charger cover by pressing it down over the charger
base until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel charger and
use it without the charger cover and charger base.
1
2
4
3
9
4235.020.2275.6.indd 9 29-09-09 09:21