Filter
Top Products
HQC333 HQC2224 ENGLISH 4203 000 54361
comb or hold it between your fingers until only the length that needs
to be cut sticks out (fig. 12).
3 Cut the hair protruding from the comb or fingers (fig. 13).
4 Continue this procedure and comb frequently to remove cut hair and
to check for unevenly cut sections.
Cleaning
.
Clean the appliance every time you have used it.
Do not use abrasives, scourers or liquids such as alcohol, petrol or acetone
to clean the appliance.
1 Make sure the appliance is switched off and unplugged.
2 Make sure the comb attachment is not attached to the appliance
(fig. 14).
Never pull at the flexible top of the comb attachment. Always pull at the
bottom part.
3 Push the middle part of the cutting unit upwards with your thumb
until it opens and then pull it off the appliance (fig. 15).
Be careful that the cutting unit does not fall to the floor.
4 Clean the cutting unit and the inside of the appliance with the brush
supplied (fig. 16).
5 Place the lug of the cutting unit into the slot and push the unit back
onto the appliance ('click') (fig. 17).
Storage
.
◗ You can store the appliance in the pouch supplied.
Replacement
.
A worn or damaged cutting unit should only be replaced with an original
Philips cutting unit.
1 Push the middle part of the cutting unit upwards with your thumb
until it opens and then pull it off the appliance (fig. 15).
2 Place the lug of the cutting unit into the slot and push the cutting unit
back ('click') (fig. 17).
Environment (HQC333 only)
.
The built-in rechargeable battery contains substances that may pollute the
environment.
Disposal of the battery
Remove the battery when you discard the appliance. Do not throw the
battery away with the normal household waste, but hand it in at an official
collection point. You can also take the appliance to a Philips service centre,
which will remove the battery for you and will dispose of it in an
environmentally safe way.
Only remove the battery if it is completely empty.
1 Disconnect the appliance from the mains and let the appliance run
until the motor stops.
2 Open and remove the cutting unit (fig. 15).
3 Remove the metal clip by means of a screwdriver (fig. 18).
4 Open the housing (fig. 19).
Insert a screwdriver into one of the grooves next to the socket for the
appliance plug. Turn the screwdriver to separate the two housing halves.
5 Insert a screwdriver into the small slot in the printed circuit board
marked with an arrow. Push the screwdriver down until part of the
printed circuit board breaks off (fig. 20)
.
6 Lift the battery out and cut the wires to separate the battery from
the power unit (fig. 21).
Do not connect the appliance to the mains again after it has been opened!
Guarantee & service
.
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care Centre
in your country (you will find its phone number in the worldwide guarantee
leaflet). If there is no Customer Care Centre in your country, turn to your
local Philips dealer or contact the Service Department of Philips Domestic
Appliances and Personal Care BV.