Philips HP 4489 Styling Iron User Manual


 
4
English
Important
Before connecting the appliance, check that the
voltage indicated on the type plate corresponds to
the local mains voltage.
Do not use this product near water in e.g. baths, washbasins,
sinks.
If the product falls into water, unplug it immediately and
dispose of it. It must not be used again.
Always ensure that the attachments are completely dry (on the
inside as well as the outside!) before affixing them to the
styler.
Always switch the appliance off before putting it down, even if
it is only for a moment.
For additional protection, the installation of a residual current
device (RCD) with a rated residual operating current not
exceeding 30 mA is advisable in the electric circuit supplying
the bathroom. Ask your electrician for advice.
Even when the appliance is switched off, the electricity has not
been cut off. Always pull out the mains plug when the
appliance is not being used.
Never obstruct the air inlet grille.
This product is equipped with an automatic overheating
protection device. If the appliance overheats, it will switch off.
Unplug the appliance. After cooling down for a few minutes,
the appliance can be used again. Before reusing, check the air
inlet grille for possible blockage by fluff, hair, etc. If in doubt,
consult your dealer or an Authorised Philips Service Centre.
Your new Philips Salon Multi Styler has been specially designed to give
beautiful styling results. It is quick and easy to use. We hope you will
enjoy using your Salon Multi Styler - the hairstyler with which you can
create any desired hairdo.
In order to get the best results, please read the instructions carefully
before use. Also refer to the illustrations on fold-out page 3.